The first step is to remove all components of the bike is only with the box, to make such
maintain these tables we use to thoroughly clean and grease in assembling all components bicycle.
Once we have the table free components, proceed to remove the bearings.
The front triangle is based on an eccentric which is supported by two bearings.
The amplitude of these movements is very small (about 2 cm
The Tie rod which is the junction with the absorber, is supported by the two pairs of sleeves, attached by a screw. These caps are
cause most of the sounds they make this type of suspension.
Clean all parts thoroughly checking its perfect condition and replace if they show signs of fatigue, and wear.
Removing bearings
The two smaller bearings
tilt are removed with a screwdriver by slight pressure on both sides.
For ro
commandments of the eccentric, we must proceed in two stages so as not to damage the cam or the triangle.
First, we must remove, using a tube, a piece of wood or as seen in the picture with a deck of a diameter slightly less than that of the eccentric,
unit bearings and
the eccentric. Secondly, once
remove the bearings removed with a screwdriver.
Decathlon Provides a major bearing kit
axis tilt and
The Mount
The procedure is relatively simple. The rocker and the Tie rod bearings
For Tilt, we must first turn set that aside and then complete the setting with the other side. Grease in all caps and the central part through shafts. It is advisable to apply fixative screws to tighten the tips (Recall that in applying this fixative is recommended not to apply any stress on these parts between 3 and 6 hours)
Beware of not over tighten the rocker as it could be subsequently blocked. The Tie rod should present no lateral movement, but should be slightly open with a motion from top to bottom.
Article published in this link http://www.vtt.org/article.php?id_article=455
0 comments:
Post a Comment